Setting Up a Fight
This chapter is for the DM. It says what your players see where that matters.
A fight starts from an encounter that is running on the Play tab. The chapter Photos, Clues and Encounters covers preparing one. Tap the fighter icon in the map's toolbar. Combat Setup opens, with the encounter's monsters and its map already loaded.
Who is in the fight
- Player characters. Every connected player has a row, ticked. Untick a row to leave that character out.
- Monsters. Every living monster in the encounter comes along. You cannot add or rename one here. You can add one once the fight is running.
- One room at a time. To fight only some of the monsters, select them on the map first, then tap the fighter icon. A line above the monster list counts them, such as "3 of 9 monsters, from your selection". Take all 9 on that line brings the rest. The chapter Running a Fight covers selecting.
Two things on a row are yours to change:
- Hostile or Friendly, on each monster's row. A Friendly monster does not block the party's way or stop their travel. Your players are not told which is which.
- Speed, the box at the right of each player's row. It is how far the character can move each turn. It starts at the speed on that player's character, or 30 feet. Type over it when you need to.
The map on this screen is a picture. You cannot move a token, set a status or change the map here. Do those on the map itself.
Initiative
Every fighter needs a number. There are three ways to give one.
- Type it. Tap the dash on a row and type. Next saves the number and moves to the next fighter without one. Done saves it and closes.
- Read a player's dice. As a player, tap the die in the map's toolbar, choose Initiative and photograph your roll. The photo appears on everyone's map, and as a small picture on your row of Combat Setup. As the DM, tap the picture, type the number and tap Set Initiative. The photo then leaves every screen. The chapter Dice Are Photos covers the camera.
- Roll for the monsters. Roll monster initiative gives every monster a d20 plus its initiative modifier. This is the one place where Far Table rolls dice, and it is for monsters only. It asks before it replaces numbers, and you can type over any of them. If the app cannot load a monster's modifier, it says so, and you type the numbers yourself.
What the players see
Players never see Combat Setup. They stay on the map.
- If the party was exploring, opening Combat Setup holds everyone where they stand. A player's map reads Held by DM. If you go back without starting the fight, they stay held until you tap Play. The chapter Exploring covers this.
- They have no tracker until the fight starts.
Starting
Start Combat, at the bottom of the screen, stays locked until the fight has a map, at least one fighter, and a number for every fighter. While it is locked, it names what is missing.
Tap it and you are back on the map, with the tracker running on every device. If the map has no scale, a message says so. Set one: movement and distances need it.
Statuses and conditions from an earlier fight in the same encounter carry into this one.
What begins hidden
A monster you have not revealed starts the fight hidden. Your players see no token for it and no row in the tracker.
Monsters are hidden when the encounter starts, not when the fight starts. One you revealed while the party explored stays revealed. To reveal the rest, see the chapter Running a Fight.